Here are some example entries for the last few days. I went to the Vara-HF window and opened the log. I notice that in the "VARA-HF command stream" window, I'm seeing a lot of "WRONG" messages. That's the extent of 'control' I could establish between the computer and radio.Īlright, doing more tinkering this morning. It WOULD change the frequency on the radio when I changed it in VarAC but radio mode went to FSR. ( now called HDSDR) Omnirig Cat software (A COM component for transceiver/receiver CAT.
Did a full restart on the computer, opened VarAC and the subsequent settings window and tried OmniRig as the desired control mechanism. FLDIGI Installation and Configuration HOW TO First things first. Tried several more times with no new results (definition of insanity.?) SO, I downloaded OmniRig again and installed that and configured it for the TS-590.
Opened the settings window again and, sure enough, 'Kenwood Transceiver' was not selected. Made sure the rest of the settings were correct and hit save & close. That dropdown window, of course, only has two options so, selecting the Kenwood option was obvious. This morning I upgraded my VARA HF to 4.50, and VarAC and tried again. It (the dropdown window) started working sometime the second day I was working with it but when frustration set in the day after that, I deleted everything (VarAC as well as OmniRig) off my computer. I would "Save and close" but could open the settings window right back up again and nothing would be selected in that dropdown window. when I DID use the CAT control option, I did use the Kenwood Transceiver selection. One thing that was happening a few days ago, before I sat it all aside for a bit.
Try connecting the K2 with an ordinary USB to Serial cable (No Rigblaster) if everything works OK then you have proved that your radio and Omnirig are working OK and you should consult West Mountain Radio for an answer 2.
I don't know what that means or why it's in there. Yaesu FT450 the command Omnirig sends is TX1 So a couple of suggestions for you 1. But the settings then, as they are now, are the default port 8300. No recollection of specific conditions at that time. I don't know why that log entry says that. sound DSP-filter also What is Omnirig Fldigi settings The new installation is located in Program Files (x86)Omni-Rig V2Omnirig2 x with SDR-Console.